PabloPicasso

Happened to me too. Went to pick uo a new to me boat. Dropped into the water post survey and throttle cable let go. Yard owner gave me...

I habe used tek 7 to attach the gaitor successfully. It was still securely attached several years later when I sold the boat. I used a...

Ha ha

Is there a phone/tablet app that can daw a polar graph from a B&G vulcan plotter. One that can update as we sail?

Ok ok. We can all agree that we'd be better off using reliable suppliers with a history of good service So who/where are these great...

Okay, so my system is a Seldon Furlex 104S. Will I be able to pull the stay through?

You could, and perhaps should, fit a bubble leak test valve. It goes after the gas cylinder hose, and before any fixed pioework...

See the pic and description at the bottom of this page Corrosion

Try copius amounts of boiling water (fresh water). Often works and is easy to do.

I will check what type of furler it is next I'm aboard 🙂

Most furlers have two parts to each section .... an inner plastic and then the outer alloy extrusion. Replacing a stay in a furler - if...

Its very unlikely you'll be able to withdraw the forestay from the furler. They usually have nylon spacers or, as above a plastic figure...

How does one replace the wire inside a forestay furler? Once the mast is down and stays removed from the mast, is it easy to slide the...

I'm intereted in a Gennaker/cruising chute for a 30 footer. If anyone has one...